GoBE Campers > Roadshower We are a small camper builder @ gobecampers.com and we have done several builds with a Roadshower. In every instance, we have found the build quality to be consistent and everything packaged and organized neatly. More importantly, we have seen a commitment to be continuously improving the product and accessory design. We have seen a few slight variations over the last couple years and each time we have been pleased with the subtle changes.

Epic fail on our first use Epic fail on our first use. I was concerned with the hose connection from the start and sure enough, the hose came loose while on the road. We lost all pressure and water, essentially making it unusable. The hose connectors won’t tighten enough now to hold pressure. Additionally, while the brackets held the unit securely, tightening, or removing, the nuts is an hour long process. If I can get the hose to pressurize I’ll give the unit another try, but for now it sits usually in our garage. Awaiting new hose... Yes, please send me the new hose. What information do you need in order to send it to me? Thank you for the response. New hose on its way. Thank you so much. I’m updating my rating, as such.

I recently received my roadshower 4L I recently received my roadshower 4L. It arrived quickly and was well packaged so there wouldn't be any damage. The two rails make mounting it very versatile. Used it twice and it gives me about three showers with one fill. The water heats up really quick even when the outside temps aren't that high. The quality is top notch, and customer service is stellar. If you have any issues, reach out, and they respond very quickly.

Great buy compared to what's out there!! Great product!! Have had it permanently on my rig since I've bought it (possibly 2-3 months now) One down side is that it does slip off a bit where I have it mounted it (I use the all-pro pack rack on my Tacoma) and have needed to add a layer of rubber padding under the roadshower itself aside from the ones that come on the curved pieces. Also, trying to tighten the bolts became a problem early on. Eventually the screw would no longer grab on the channels and had to use pliers to hold screws in place as I tightened bolts. May need a way to work around this issue. Aside from those problems the product itself worked great and water flowed continuously while pressurized.

Be careful mounting I'm only going to criticize for the company's sake. Your alloy is so soft that the installation bolts dig into the mounting channels. Especially because you provide nylon lock nuts. It'd be better off with lock washers or at least provide torque specs. It was a huge pain to change my install because the bolts were stuck in the mounting channels.