Mopar Sucks Imagine my consternation when I found out that I needed a new ECM because my voltage regulator went bad. Then, on top of that, the Dealer would charge an arm and a leg, and the part was 7-10 days out. I opted instead to check the internet and found MAK's where I found my ECM for a reasonable fee, shipped within a day of my order, and pre-programmed! Five Stars, fully recommend

Just found out they now have two… Just found out they now have two websites, exactly the same, just with different names. The address and contact info is exactly the same. tipmrebuilders(dot)com/contact-us/ ecmrebuilders(dot)com/contact-us/ Listed below is my original review that they have tried multiple times for me to remove: Ordered a computer for a 97 Dodge Dakota, received in a timely manner. Did not work. Started and died repeatedly. Contacted and shipped back, received a second pcm. Exact same issue. I tried to explain there are two different computers based on whether the vehicle has security or not. Person argued with me on phone and said the only thing they could do was test the pcm to make sure there wasn't any issues. I said I'll send it back, you can keep it, I want a refund. I was told I'd be charged a rental fee for my time in possession of it. I ordered a pcm from AMAZON (cardone), received it yesterday, and it FIRED UP ON THE FIRST KEY TURN!!! It runs and drives absolutely perfectly and shifts into all gears again. So thank you for not listening to me over what could've been an easy fix, charging me $25 for a rental fee on multiple incorrect pcms, and overall just wasting my time.

Worked as intended Worked as intended. unit arrived timely and CS helped assist an incorrect address change just before shipping. Will use again

Finding the correct PCM was straight… Finding the correct PCM was straight forward and simple. After I ordered I had a small question and it was answered clearly. Great directions for installation and it has worked perfectly for 300 miles.

Everything with the ecm works great but… Everything with the ecm works great but when I put a scan tool on it found that it was programed with a different Vin so I emailed support and the responded and ask what it was showing and what the correct Vin should be never got any email back and waited a week and emailed them again with everything and never got a response